Siemens SINUMERIK Series Function Manual page 892

Extended functions
Hide thumbs Also See for SINUMERIK Series:
Table of Contents

Advertisement

Z2: NC/PLC interface signals
18.9 Punching and Nibbling (N4)
DB21, ...
DBX3.2
Edge evaluation:
Signal state 1 or
This signal simply prevents execution of the stroke. The machine traverses anyway.
edge change 0 → 1
The automatic path segmentation remains active if it is already activated.
Only the signal "Stroke initiation" is suppressed.
The machine traverses in "stop and go" mode.
The step length is defined via the path segmentation.
1 signal: Stroke suppression is active.
Signal state 0 or
0 signal: Stroke suppression is not active.
edge change 1 → 0
DB21, ...
DBX3.3
Edge evaluation:
Signal state 1 or
A "Delayed stroke" can be activated via this signal. This corresponds in function to the
edge change 0 → 1
programming of
in the NCK. With the exception of the manual stroke initiation, the evaluation of signals is limited to
PON
1 signal: Delayed stroke is active.
Signal state 0 or
0 signal: Delayed stroke is not active.
edge change 1 → 0
DB21, ...
DBX3.4
Edge evaluation:
Signal state 1 or
The NC reacts to this signal by initiating an immediate movement stop. An alarm is output if any
edge change 0 → 1
other movement or action needs to be interrupted as a result of this signal.
In physical terms, the signal is identical to the signal "Stroke active" for the CNC, i.e. the system is
wired in such a way that the two signals are taken to the same NC input via an AND gate.
1 signal: Stroke inoperative (corresponds to the signal "stroke enable").
Signal state 0 or
0 signal: Stroke operative (corresponds to the signal "stroke enable").
edge change 1 → 0
892
Stroke suppression
Signal(s) updated:
Delayed stroke
Signal(s) updated:
. Other PLC signals not corresponding to the standard are not evaluated
PDELAYON
active.
Stroke inoperative
Signal(s) updated:
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 840d slSinumerik 828d

Table of Contents