Siemens SINUMERIK Series Function Manual page 158

H1: Manual and handwheel travel
3.4 Handwheel travel in JOG
Travel command
Depending on the setting in machine data MD11324
$MN_HANDWH_VDI_REPRESENTATION (see Section "Parameter assignment
(Page 161)"), the following interface signal is output to the PC already when a travel request
is present or not until the axis moves:
● Machine axes:
● Geometry axis 1:
● Geometry axis 2:
● Geometry axis 3:
● Orientation axis 1:
● Orientation axis 2:
● Orientation axis 3:
Invert handwheel direction of rotation
The handwheel direction of rotation can be inverted, if the direction of movement of the
handwheel does not match the expected direction of motion of the axis. The adaptation can
be especially necessary, if a handwheel (HT2, HT8) can be assigned to various axes.
158
– DB31, ... DBX64.6 (minus travel command) or
– DB31, ... DBX64.7 (plus travel command)
– DB21, ... DBX40.6 (geometry axis 1: Minus travel command) or
– DB21, ... DBX40.7 (geometry axis 1: Plus travel command)
– DB21, ... DBX46.6 (geometry axis 2: Minus travel command) or
– DB21, ... DBX46.7 (geometry axis 2: Plus travel command)
– DB21, ... DBX52.6 (geometry axis 3: Minus travel command) or
– DB21, ... DBX52.7 (geometry axis 3: Plus travel command)
– DB21, ... DBX332.6 (orientation axis 1: Minus travel command) or
– DB21, ... DBX332.7 (orientation axis 1: Plus travel command)
– DB21, ... DBX336.6 (orientation axis 2: Minus travel command) or
– DB21, ... DBX336.7 (orientation axis 2: Plus travel command)
– DB21, ... DBX340.6 (orientation axis 3: Minus travel command) or
– DB21, ... DBX340.7 (orientation axis 3: Plus travel command)
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions