Siemens SINUMERIK Series Function Manual page 73

N: SINUMERIK 840D sl, NCU 7x0.3 PN
● Internal SINUMERIK Operate user interface
● Machine control panel (MCP)
Installation and connection
References
● TCU, MCP, PCU:
● NCU:
● Machine control panel (MCP)
● Switch SCALANCE:
Configuration, commissioning and parameter assignment
References
● Structure of the system network and commissioning of a TCU:
● Configuration of the channel menu
Programming
References
● MCP:
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Because of the existing external SINUMERIK Operate user interface on PCU 50.x in the
system network, the NCU-integrated internal SINUMERIK Operate user interface must be
switched off. The internal SINUMERIK Operate user interface must not be switched off
only when it is used with a limited range of functions, exclusively within the scope of tool
management. Detailed information on this can be found in the Commissioning Manual
"Operator Components and Networking (IM5)", Section "Network configuration" >
"Application example"
For a flexible switchover of the machine control panels, only one MCP can be connected
to one NCU. The switchover of the MCPs is user-specifically via the PLC user program
(function block FB 9).
SINUMERIK 840D sl Operator Components and Networking Manual
SINUMERIK 840D sl NCU 7x0.3 PN Manual
FB 9: MtoN Control Unit Switchover
Communication with SIMATIC System Manual
Operator Components and Networking Commissioning Manual (IM5)
SINUMERIK Operate Commissioning Manual (IM9), Section "Channel menu"
Basic Functions Function Manual, Section "P3 Basic PLC program for SINUMERIK 840D
sl" > "Block descriptions" > "FB 9: MtoN control unit switchover"
B3: Distributed systems - 840D sl only
2.1 Brief description
73