Replace The Torque Hub Oil; Replace The Hydraulic Tank Filter - Genie Z-45/22 Service Manual

Service Manual - Second Edition
800-610-4101
ActionRental.com
C-5

Replace the Torque Hub Oil

Replacing the torque hub oil is essential for good
machine performance and service life. Failure to
replace the torque hub oil at yearly intervals may
cause the machine to perform poorly and
continued use may cause component damage.
1 Select the torque hub to be serviced. Then
drive the machine until one of the two plugs is
at the lowest point.
2 Remove both plugs and drain the oil.
3 Drive the machine until one plug is at the top
and the other is at 90 degrees.
4 Fill the hub with oil from the top hole until the oil
level is even with the bottom of the side hole.
Apply pipe thread sealant to the plugs, and
then install the plugs.
5 Repeat steps 1 through 4 for all the other drive
torque hubs.
Specifications
Capacity
Type
Part No. 32960
C-6
Replace the
Hydraulic Tank Filter
Replacement of the hydraulic tank filter is
essential for good machine performance and
service life. A dirty or clogged filter may cause the
machine to perform poorly and continued use may
cause component damage. Extremely dirty
conditions may require that the filter be replaced
more frequently.
1 Remove the filter with an oil filter wrench.
2 Apply a thin layer of oil to the new oil filter
3 Install the new filter (part no. 20293) and
4 Start the engine from the ground controls.
5 Inspect the filter and related components to be
17 fluid ounces
0.5 liters
SAE 90 multipurpose
hypoid gear oil.
API classification GL5
Genie Z-45/22
Section 4 - Scheduled Maintenance Procedures
TABLE C PROCEDURES
Beware of hot oil. Contact with hot
oil may cause severe burns.
Perform this procedure with the
engine off.
gasket.
tighten it securely by hand. Clean up any oil
that may have spilled during the installation
procedure.
sure that there are no leaks.
4 - 29