Siemens Simatic ET 200SP Manual page 134

Article number
– Monitoring of instantaneous and half-
wave values
– THD measurement for current and volt-
age
– Harmonics for current and voltage
– Voltage dip (DIP)
– Voltage swell
I&M data
•
Isochronous mode
•
Engineering with
STEP 7 TIA Portal configurable/integrated
•
as of version
STEP 7 configurable/integrated as of ver-
•
sion
PROFIBUS as of GSD version/GSD revi-
•
sion
PROFINET as of GSD version/GSD revi-
•
sion
Operating mode
Switching between operating modes in
•
RUN
Cyclic measured value access
•
Acyclic measured value access
•
Fixed measured value sets
•
Freely definable measured value sets
•
CiR – Configuration in RUN
Reparameterization possible in RUN
Calibration possible in RUN
Installation type/mounting
Mounting position
Supply voltage
Design of the power supply
Type of supply voltage
permissible range, lower limit (DC)
permissible range, upper limit (DC)
Input current
Current consumption (rated value)
Current consumption, max.
Analog input module AI Energy Meter 480VAC/CT HF (6ES7134-6PA00-0CU0)
Manual, 07/2018, A5E42674880-AA
6ES7134-6PA00-0CU0
Yes
Yes
Yes
Yes
Yes
Yes; I&M0 to I&M3
No
STEP 7 V15 or higher
Configurable via GSD file
One GSD file each, Revision 3 and 5 and higher
V2.3
Yes; For module version 32 I/20 Q, it is possible
to dynamically switch between 25 user data vari-
ants, 23 of which are pre-defined and 2 of which
can be defined by the specific user
Yes
Yes
Yes
Yes
Yes
Yes
Any
DC
24 V DC
19.2 V
28.8 V
12.5 mA
17 mA
Technical specifications
15.1 Technical specifications
133