Siemens Simatic ET 200SP Manual page 108

Limit
Enter the limit that is to trigger a limit violation when exceeded or fallen below. Limit
violations are displayed in the user data and in DS 150.
Type
Select whether it is a high or low limit. Depending on this selection, the limit violation or
hardware interrupt is triggered when a value exceeds (high limit) or falls below (low limit) the
limit.
Hysteresis for limit monitoring [0.1%]
Enter the hysteresis for limit in percent.
The hysteresis band is below the high limit or above the low limit. The parameter in % refers
to the configured limit. If a measured value fluctuates around the limit but does not leave the
hysteresis band, a new limit violation is not triggered.
Delay time for limit monitoring [s]
Select the delay time for limit violation. The delay refers to the time that must elapse before
an occurrence of a limit violation is reported. Faults can be filtered out by selection of the
delay time. The deceleration time is also taken into consideration during outgoing of the limit
violation.
User data mapping I/II
Number of measured values
Specify the number of measured values/variables that you want to use for the user-specific
user data mapping.
Measured variable
Select the measured variable (with the measured value ID (Page 163)) that you want to use
for the user-specific user data mapping.
Data record mapping
Number of measured values
Specify the number of measured values/variables that you want to use for the user-specific
data record mapping.
Measured variable
Select the measured variable (with the measured value ID (Page 163)) that you want to use
for the user-specific data record mapping.
Analog input module AI Energy Meter 480VAC/CT HF (6ES7134-6PA00-0CU0)
Manual, 07/2018, A5E42674880-AA
Parameters
13.2 Description of parameters
107