Description Of Parameters - Siemens Simatic ET 200SP Manual

13.2

Description of parameters

Hardware interrupt
Enable the hardware interrupt for the entire module here.
Inputs
Diagnostics: Missing supply voltage L+
Activate the diagnostics No supply voltage L+. If there is no voltage or too little voltage at
terminal 17, the message "No supply voltage" is output and a diagnostic interrupt is
triggered.
Connection type
Specify the connection type you used for the AI Energy Meter HF.
For more detailed information, refer to "Connection examples (Page 23)".
Voltage measuring range
Here you set the voltage measuring range in which the system connected to the AI Energy
Meter HF works.
Line frequency
Here you set the line frequency in which the system connected to the AI Energy Meter HF
works.
Enable gate energy meter
Enable the gate for the energy meter When the gate is enabled, the energy meter only
counts when the corresponding output data bit (DQ bit) is set to "1".
End value energy meter
Select the end value for the periodic counting of the energy meter. You can also specify that
the energy meter is to count without a full-scale value (infinite counting). The calculated
energy counter values are stored retentively in the module.
User data variant
Select user data variant with which the module is to operate once it is started up.
Analog input module AI Energy Meter 480VAC/CT HF (6ES7134-6PA00-0CU0)
Manual, 07/2018, A5E42674880-AA
Parameters
13.2 Description of parameters
101