Sample Wiring Of Vector Drives Connected In Parallel - Siemens SINAMICS S120 Function Manual

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Sample wiring of Vector drives connected in parallel

Drive line-up with two parallel-connected Line Modules and Motor Modules (chassis) of the same type

Parallel-connected Line Modules (chassis) and Motor Modules (chassis) of the same type

can be connected to a DRIVE-CLiQ interface of the Control Unit.

In the following diagram, two Active Line Modules and two Motor Modules are connected to

the X100 and X101 interface.

For further information on parallel connection, see the chapter "Parallel connection of power

units" in this Function Manual.

This topology does not match the topology created offline by STARTER and must be

Figure 12-28 Drive line-up with parallel-connected power units (chassis)

Drive functions

Function Manual, (FH1), 10/2008, 6SL3097-2AB00-0BP5

Basic information about the drive system

12.10 Rules for wiring with DRIVE-CLiQ