Siemens SINAMICS S120 Function Manual page 118

Servo control
3.18 Variable signaling function
Function diagram (see SINAMICS S120/S150 List Manual)
● 5301 Servo control - variable signaling function
Overview of important parameters (see SINAMICS S120/S150 List Manual)
● p3290 Start variable signaling function
● p3291 Variable signaling function signal source
● p3292 Variable signaling function signal source address
● p3293 Variable signaling function signal source data type
● p3294 Variable signaling function output signal
● p3295 Variable signaling function threshold value
● p3296 Variable signaling function hysteresis
● p3297 Variable signaling function pull-in delay [ms]
● p3298 Variable signaling function drop-out delay [ms]
Note:
The variable signaling function works with an accuracy of 8 ms (also to be taken into account
for pull-in and drop-out delay).
118
Bit 0 = 0: Stop variable signaling function (default)
Bit 0 = 1: Start variable signaling function with current parameter settings
Bit 1 = 0: Compare without sign
Bit 1 = 1: Compare with sign (default)
BICO source, with which the connector parameters or parameters with the
attribute traceable can be connected.
Set the address of the signal source for the variable signaling function
Set the data type of the signal source for the variable signaling function
Display the output signal for the variable signaling function.
Specify the signal source (binector parameter), individual bits
can be interconnected.
Set the threshold value for the variable signaling function.
Set the hysteresis for the variable signaling function.
Set the pull-in delay for the variable signaling function.
The output signal is set if the condition for a 1 signal is fulfilled for a longer period
than the programmed pull-in delay.
Set the drop-out delay for the variable signaling function.
The output signal is reset if the condition for a 0 signal is fulfilled for a longer period
than the programmed drop-out delay.
Function Manual, (FH1), 10/2008, 6SL3097-2AB00-0BP5
Drive functions