Fluke 5080A Service Manual page 13

A Warning identifies conditions and procedures that are dangerous to the user.
A Caution identifies conditions and procedures that can cause damage to the
Product or the equipment under test.
To prevent possible electrical shock, fire, or personal injury:
•
Use the Product only as specified, or the protection
supplied by the Product can be compromised.
•
Do not apply more than 264 V ac rms between the supply
conductors or between either supply conductor and ground.
• Use caution when working with voltages above 30 V ac rms,
42 V peak, or 60 V dc. These voltages pose a shock hazard.
•
Make sure the ground conductor in the mains power cord is
connected to a protective earth ground. Disruption of the
protective earth could put voltage on the chassis that could
cause death.
•
Replace a blown fuse with exact replacement only for
continued protection against arc flash.
•
Do not put the Product where access to the mains power
cord is blocked.
•
Use only the mains power cord and connector approved for
the voltage and plug configuration in your country and rated
for the Product.
•
Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
• Verify the voltage applied to the unit under test (UUT) does
not exceed the insulation rating of the UUT and the
interconnecting cables.
• Do not operate the Product with covers removed or the case
open. Hazardous voltage exposure is possible.
•
Do not use the Product if it is damaged.
•
Disable the Product if it is damaged.
To avoid damage to the Product, do not apply voltage in excess
of the marked rating to any terminal.
XW Warning
W Caution
Calibrator
Safety Information
3