Show Interface - Cisco Firepower 4100 Command Reference Manual

S Commands

show interface

To view Ethernet interface status, use the show interface command.
show interface [detail | expand | fsm status | interface_id]
Syntax Description
detail
expand
fsm status
interface_id
scope eth-uplink/scope fabric a/
Command Modes
Command History
Release
2.4(1)
1.1(1)
This command only applies to Ethernet interfaces. For EtherChannels, see the show port-channel command.
Usage Guidelines
For subinterfaces, see the show subinterface command.
Example
The following is sample output from the show interface command.
firepower# scope eth-uplink
firepower /eth-uplink # scope fabric a
firepower /eth-uplink/fabric # show interface
Interface:
Reason
--------------- ------------------ ----------- ---------------- ------------ ------------
Shows detailed interface information.
Shows information about interfaces in a non-tabular view, as well as information
about subinterfaces.
Shows Finite State Machine (FSM) status.
Shows information about a particular Ethernet interface, for example,
Ethernet1/4.
Modification
Additional fields were added for VLAN subinterfaces.
Command added.
Port Name Port Type
Ethernet1/2 Data
Ethernet1/4 Mgmt
Ethernet1/5 Data
Ethernet1/7 Firepower Eventing Enabled
Ethernet1/8 Data
Ethernet2/1 Data
Ethernet2/2 Data
Ethernet2/3 Data
Ethernet2/4 Data
Ethernet2/5 Data
Ethernet2/6 Data
Ethernet2/7 Data
Admin State Oper State
Enabled Up
Enabled Up
Enabled Up
Up
Disabled Sfp Not Present
Disabled Sfp Not Present
Disabled Sfp Not Present
Disabled Sfp Not Present
Disabled Sfp Not Present
Disabled Sfp Not Present
Disabled Sfp Not Present
Disabled Sfp Not Present
Cisco Firepower 4100/9300 FXOS Command Reference
show interface
Allowed Vlan State
All
All
Untagged
All
All Unknown
All Unknown
All Unknown
All Unknown
All Unknown
All Unknown
All Unknown
All Unknown
277