Connect Local-Mgmt - Cisco Firepower 4100 Command Reference Manual

connect local-mgmt

connect local-mgmt
To connect to the local-mgmt command shell, use the connect local-mgmt command.
connect local-mgmt [a]
Syntax Description
a
Any command mode
Command Modes
Command History
Release
1.1(1)
Refer to
Usage Guidelines
To exit the local-mgmt mode, enter exit.
Example
The following example shows how to connect to the local-mgmt command shell, and view available
commands:
firepower# connect local-mgmt
firepower(local-mgmt)#
cd
clear
cluster
connect
copy
cp
delete
dir
enable
end
erase
erase-log-config
exit
fips
ls
mgmt-port
mkdir
move
mv
ping
ping6
pwd
reboot
restore-check
rm
rmdir
Cisco Firepower 4100/9300 FXOS Command Reference
46
(Optional) Connects to fabric a.
Note
Modification
Command added.
connect local-mgmt: Command List, on page 409
?
Change current directory
Clear managed objects
Cluster mode
Connect to Another CLI
Copy a file
Copy a file
Delete managed objects
Show content of dir
Enable
Go to exec mode
Erase
Erase the mgmt logging config file
Exit from command interpreter
FIPS compliance
Show content of dir
Management Port
Create a directory
Move a file
Move a file
Test network reachability
Test IPv6 network reachability
Print current directory
Reboots Fabric Interconnect
Check if in restore mode
Remove a file
Remove a directory
The fabric ID is always a. If you omit the fabric ID, you are
connected to fabric A.
for additional information.
A R Commands