Create Policy (Callhome) - Cisco Firepower 4100 Command Reference Manual

A R Commands

create policy (callhome)

To add a new Smart Call Home and Smart Licensing policy, use the create policy command. If a policy with
the specified name already exists, the command will fail.
To add or edit an IPSec connection, use the enter policy command. If the specified policy does not exist, it
is created and entered; if the policy exists, it is entered.
You also can use the scope form of this command to enter an existing policy to assign or change properties.
To delete an existing policy, use the delete form of this command.
create policy event
delete policy event
enter policy event
scope policy event
Syntax Description
event
scope monitoring/scope callhome/
Command Modes
Command History
Release
1.1(1)
When you create a new Smart Call Home policy, you are automatically entered into callhome/policy mode
Usage Guidelines
(monitoring/callhome/policy) with an asterisk indicating the new policy is not yet committed. You can set
property values and enable/disable services, and then commit the new policy.
After you create a Smart Call Home policy, the policy name cannot be changed. You must delete the policy
and create a new one.
Use this command to create an instance of a policy for an existing type of fault or system event. The available
keywords for Call Home policy event types are:
• adaptor-mismatch
• arp-targets-config-error
• association-failed
• configuration-failure
• connectivity-problem
• election-failure
• equipment-degraded
• equipment-disabled
• equipment-inaccessible
• equipment-inoperable
The fault or system event type. See Usage Guidelines below for event options.
Modification
Command added.
Cisco Firepower 4100/9300 FXOS Command Reference
create policy (callhome)
67