Plug In And Power Up The Appliance; Log In To The Appliance; Web-Based Interface - Cisco M190 Quick Start Manual

Plug In and Power Up the Appliance

Log In to the Appliance

Web-Based Interface

8
Plug in the appliance, then power up the appliance by pressing the On/Off
switch on the front panel of the Cisco M190. You must wait 10 minutes for the
system to initialize each time you power up the system.
After the machine powers up, solid green lights on the front of the appliance
indicate that the appliance is operational. The network activity light will be
green but may not be solid.
If turned on quickly after connecting power to the appliance, the
Caution
appliance powers up, the fans spin and the LEDs turn on. Within
30-60 seconds, the fans stop and all LEDs turn off. The appliance
powers on 31 seconds later. This behavior is by design to allow the
system firmware and controller to synchronize. 

Wait at least 10 minutes for the system to complete the power up
sequence and the LEDs to turn green. If you turn the power off
before the initialization is complete, the appliance will NOT reach
an operational state and must be returned to Cisco.
You can log into the Cisco M190 using the web-based interface or the command
line interface.
For web browser access via the Ethernet port (see the
Step 1
Appliance" section on page
entering the following URL in a web browser:
http://192.168.42.42
Enter the following login information:
Step 2
Username: admin
•
Password: ironport
•
7), log in to the Cisco M190 appliance by
"Connect to the