Chapter 8 How To Use The Configuration Tool; Setting Flow Chart - Mitsubishi MELSEC Q series User Manual

CHAPTER 8
This chapter describes the setting procedure and operations for data logging.
8.1

Setting Flow Chart

Follow the flow chart below to configure the settings.
Stop the data logging.
HOW TO USE THE CONFIGURATION
TOOL
Start
Configure the auto logging settings.
No
Enable auto logging?
Yes
Configure the auto logging settings.
No
Is data logging stopped?
Yes
Write the settings.
Start the data logging.
Stop the data logging.
Read the data logging file from the
SD memory card.
Check the CSV file.
End

CHAPTER 8 HOW TO USE THE CONFIGURATION TOOL

Configure the settings required for data
logging.
( Page 110, Section 8.4)
( Page 134, Section 8.5.1)
Before writing common settings, all the data
logging must be stopped.
( Page 145, Section 8.8)
( Page 145, Section 8.8)
Execute or stop the data logging.
( Page 149, Section 8.10)
( Page 152, Section 8.11)
8
95