Display Flowchart - Delta Electronics ASDA-B2 series User Manual

Chapter 4 Display and Operation

4.2 Display Flowchart

Figure 4.2 Keypad Operation
1. When the power is applied to the AC servo drive, the LCD display will show the
monitor function codes for approximately one second, then enter into the monitor
mode.
2. In monitor mode, pressing MODE key can enter into parameter mode. In parameter
mode, pressing MODE key can return to monitor mode.
3. No matter working in which mode, when an alarm occurs, the system will enter into
fault mode immediately. In fault mode, pressing MODE key can switch to other
modes. In other modes, if no key is pressed for over 20 seconds, the system will
return to fault mode automatically.
4. In monitor mode, pressing UP or DOWN arrow key can switch monitor parameter
code. At this time, monitor display symbol will display for approximately one second.
5. In monitor mode, pressing MODE key can enter into parameter mode, pressing the
SHIFT key can switch parameter group and pressing UP or DOWN arrow key can
change parameter group code.
6. In parameter mode, the system will enter into the setting mode immediately after the
Set key is pressed. The LCD display will display the corresponding setting value of
this parameter simultaneously. Then, users can use UP or DOWN arrow key to
change parameter value or press MODE key to exit and return back to the
parameter mode.
7. In parameter setting mode, the users can move the cursor to left by pressing the
SHIFT key and change the parameter settings (blinking digits) by pressing the UP or
DOWN arrow key.
8. After the setting value change is completed, press SET key to save parameter
settings or execute command.
4-2
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
ASDA-B2
Revision September 2013