Emi Filter Selection - Delta Electronics ASDA-B2 series User Manual

Chapter 2 Installation and Storage

2.6 EMI Filter Selection

AC Servo Drive - EMI Filter Cross Reference
Item Power
1 100W
2 200W
3 400W
4 750W
5 1000W
6 1500W
7 2000W
8 3000W
Installation
All electrical equipment, including AC servo drives, will generate high-frequency/low-
frequency noise and will interfere with peripheral equipment by radiation or conduction
when in operation. By using an EMI filter with correct installation, much of the interference
can be eliminated. It is recommended to use Delta's EMI filter to have the best interference
elimination performance.
We assure that it can comply with following rules when AC servo drive and EMI filter are
installed and wired according to user manual:
 EN61000-6-4 (2001)
 EN61800-3 (2004) PDS of category C2
 EN55011+A2 (2007) Class A Group 1
General Precaution
To ensure the best interference elimination performance when using Delta's EMI filter,
please follow the guidelines in this user manual to perform wiring and/or installation. In
addition, please also observe the following precautions:
 EMI filter and AC servo drive should be installed on the same metal plate.
 Please install AC servo drive on same footprint with EMI filter or install EMI filter as
close as possible to the AC servo drive.
 All wiring should be as short as possible.
 Metal plate should be grounded.
 The cover of EMI filter and AC servo drive or grounding should be fixed on the metal
2-6
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
Servo Drive Model
ASD-B2-0121-B
ASD-B2-0221-B
ASD-B2-0421-B
ASD-B2-0721-B
ASD-B2-1021-B
ASD-B2-1521-B
ASD-B2-2023-B
ASD-B2-3023-B
EMI Filter Model
1PH
RF007S21AA RF022M43AA
RF007S21AA RF022M43AA
RF007S21AA RF022M43AA
RF007S21AA RF022M43AA
RF015B21AA RF075M43BA
RF015B21AA RF075M43BA
- RF037B43BA
- RF037B43BA
ASDA-B2
FootPrint
3PH
N
N
N
N
N
N
N
N
Revision September 2013