Chapter 2 Installation And Storage; Installation Notes; Storage Conditions - Delta Electronics ASDA-B2 series User Manual

Chapter 2 Installation and Storage

2.1 Installation Notes

Please pay close attention to the following installation notes:
 Do not bend or strain the connection cables between servo drive and motor.
 When mounting the servo drive, make sure to tighten all screws to secure the drive in
place.
 If the servo motor shaft is coupled directly to a rotating device ensure that the
alignment specifications of the servo motor, coupling, and device are followed. Failure
to do so may cause unnecessary loads or premature failure to the servo motor.
 If the length of cable connected between servo drive and motor is more than 20m,
please increase the wire gauge of the encoder cable and motor connection cable
(connected to U, V, W terminals).
 Make sure to tighten the screws for securing motor.

2.2 Storage Conditions

The product should be kept in the shipping carton before installation. In order to retain the
warranty coverage, the AC servo drive should be stored properly when it is not to be used
for an extended period of time. Some storage suggestions are:
 Store in a clean and dry location free from direct sunlight.
 Store within an ambient temperature range of -20°C to +65°C (-4°F to 149°F).
 Store within a relative humidity range of 0% to 90% and non-condensing.
 Do not store in a place subjected to corrosive gases and liquids.
 Store in original packaging and placed on a solid surface.
Revision September 2013
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
2-1