Using The Core Scale - Fluke OF-500-01 OptiFiber Technical Reference Handbook

OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook

Using the Core Scale

Figure 6-5 shows the rings of the scale you can use on
FiberInspector images to measure core and cladding sizes.
To use the scale, do the following:
1 Verify that the correct magnification is shown on the
FiberInspector screen. The magnification must match
the setting on the FiberInspector probe. To change the
B
magnification, press
2 Center the image, press
B
still mode; then press
The scale defaults to the core and cladding rings for
the FIBER TYPE selected on the CABLE tab in SETUP.
If the wrong Core Size and scale rings are shown, press
D
Change Scale.
Q
3 Use the softkeys to center the scale over the image
if necessary.
6-8
Camera.
E
Still to put the image in
Show Scale.
9
White
Figure 6-5. FiberInspector Core Scale (all rings shown)
μ
125 m
Red
μ
62.5 m
Yellow
μ
50 m
μ
m
Blue
ajt24f.eps