Fluke OF-500-01 OptiFiber Technical Reference Handbook page 39

A
The settings available on the current tab.
To see details about a setting, highlight the setting;
H
then press .
B
D E
Use Tab and
SETUP screen.
C
Tabs for the setup menus:
•
Job settings apply to the fiber installation you are
testing and are stored with saved test results. Use
these settings to identify the job site, set up cable ID
lists, and identify which end of the cabling you are
testing. See Chapter 2 for details.
•
System settings let you localize the tester and set
other user preferences, such as the power down
timeout and camera type.
Note
Tab to move among tabs on the
•
The Cable tab lets you select the type of fiber cable you
will test and define some cable characteristics for loss/
length tests. You can also change the index of refraction
if you do not want to use the default values.
Select a fiber type before selecting a test limit. The
fiber type determines which test limits are available.
•
The OTDR tab lets you select a test limit and wavelength
for OTDR tests and enable launch fiber compensation.
You can also change settings for Manual OTDR mode.
See Chapter 3 for details.
•
The Loss/Length tab appears if the module includes the
loss/length option or power meter option (you can run
loss tests in Far End Source mode with the power meter
option). Use this tab to configure the loss/length test. See
Chapter 6 for details.
Different or additional tabs may be available depending
on the installed module.
Getting Acquainted
Basic Features
Note
1
1-19