Testing In Smart Remote Mode - Fluke OF-500-01 OptiFiber Technical Reference Handbook

Testing in Smart Remote Mode

Use Smart Remote mode to test and certify dual-fiber
cabling. In this mode, the tester measures loss, length, and
propagation delay on two fibers at two wavelengths in one
or both directions.
A
Tester with OFTM-5612B or OFTM-5732 module and
smart remote (DTX remote shown). Match connector
adapters to the connectors in the link.
B
Memory card (optional)
C
Spare battery pack (optional)
D
Two ac adapters with line cords (optional)
Figure 7-5. Equipment for Testing in Smart Remote Mode
Using the Loss/Length Option
Testing in Smart Remote Mode
Figure 7-5 shows the equipment required for loss/length
testing in Smart Remote mode.
E
Two duplex reference test cords. Match the fiber to be
tested. Connectors for the tester and remote outputs
must be SC. For the others match the connectors in the
link.
F
Two mandrels. Recommended when testing multimode
fiber. See page 7-11.
G
Fiber cleaning supplies
7
ajt44f.eps
7-13