Selecting A Custom Limit; If The Limit Or Fiber Type Is Not Valid - Fluke OF-500-01 OptiFiber Technical Reference Handbook

OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook

Selecting a Custom Limit

To select a custom limit to use for testing, do the following:
1 Verify that the fiber type selected on the Cable tab in
Setup is used in the test limit you want to select. The
test limit will not appear if it does not support the
selected fiber type.
S
2 Press ,then select TEST LIMIT on a test's tab.
B
3 Press More, select Custom.; then select the limit
from the list.
To delete a custom limit, do the following:
F
1 Press ; then select Edit Custom Test Limit.
2 Highlight the limit; then press
11-8
B
Delete Limit.

If the Limit or Fiber Type is Not Valid

If the tester says that the limit or fiber type is not valid
when you try to run a test, you may need to add more
parameters to the configuration. For details, see "If the Test
Limit or Fiber Type is Not Valid with the Test" in Chapter 2
H
or press when the message appears.