NEC UNIVERGE SV9100 Features And Specifications page 1250

Extension numbers cannot start with 0 or 9.
Extension numbers cannot include
InMail and UM8000 Mail cannot be used at the same time in the same system.
Ring Group calls do not follow extension call forwarding to voice mail.
Caller ID information is passed from the voice mail to an extension for pre-answer display
on an unscreened transfer from voice mail.
Off-premise notification and external extensions require access to outside lines.
To have the Voice Mail Automated Attendant answer a trunk, program the trunk as a DIL to
the Voice Mail pilot.
When the voice mail places a call on hold, it uses Group Hold. Any line appearances for the
trunk shows the hold flash rate, however, users cannot pick up these calls (a busy signal is
heard).
If the Message Waiting LED is also used for Message Waiting Indication, and there are both
voice mail messages and Message Wait indications, the color set for Message Wait
overrides the color used for voice mail indications (red).
During a Conversation Record session, DTMF digits are not transmitted. If the End softkey
is used to stop the Conversation Record, DTMF to the outside party is restored. If you press
the Conversation Record button to end the recording DTMF is not restored.
Stutter Dial Tone is supported to Single Line Telephones (SLTs) for Voice Mail Message
Waiting.
When a Department Group is assigned as the VM Department Group in Program 45-01-01
it works only as priority mode no matter what Program 16-01-02 is set to for that
Department.
A modem for remote maintenance is built into the GCD-VM00 blade.
When the system has the Hotel Motel license (BE114071), the Message Waiting Indication
(MWI) on a DSS Console for an extension is a Green LED. Without the Hotel Motel license
the MWI on a DSS Console for an extension is a Red LED.
When migrating from SV8100 to SV9100, the InMail auto programs to use Department
Group 64. For example, if Department Group 64 was previously being used on the SV8100
for UM8000, the UM8000 will need to be re-programmed to use a different Department
Group.
Default Settings
Disabled
System Availability
Terminals
All Terminals
Required Component(s)
GCD-VM00
*
or .
#
1250