NEC UNIVERGE SV9100 Features And Specifications page 1234


Dial Tone Detection

Direct Inward Dialing (DID)

Programmable Function Keys

Ring Groups

Speed Dial – System/Group/Station

Trunk Group Routing
Guide to Feature Programming
Program
Program Name/Description
Number
10-09-01 DTMF and Dial Tone Circuit Setup
Allocate the circuits on the GCD-CP10 for
either DTMF receiving or dial tone detection.
Service Code Setup (for Service Access) –
11-12-14
Trunk Group Access
If the service code for Trunk Group Access (704
by default) is not acceptable, change it as
necessary.
Analog Trunk Data Setup – Next Trunk in
14-02-11
Rotary if No Dial Tone
Enable/Disable the system ability to skip over a
trunk if dial tone is not detected. This pertains to
calls using Speed Dial, ARS, Last Number
Redial, or Save Number Dialed. It does not
pertain to line keys or Direct Trunk Access calls.
Trunk Group – Trunk Group Number
14-05-01
Assign trunks to trunk groups.
Input Data
0 = Common Use
1 = Extension Only
2 = Trunk Only
MLT, SLT
*
#
0 ~ 9, , Maximum of eight
digits
0 = Disable
1 = Enable
Trunk Port 1 ~ 400 =
Priority 1 ~ 400
1234
Default
Circuit/Resource
01 ~ 08 = 1
(Extensions)
Circuit/Resource
09 ~ 32 = 2
(Trunks)
Circuit/Resource
33 ~ 144 = 0
(Common)
When
GPZ-BS10 is
installed, 81 ~
144 are available
804
0
Default = Trunks
1 ~ 400 assigned
to trunk group 1
with priorities
equal to the
trunk number.
Trunk 1 = Priority
1 Trunk 400 =
Priority 400.