NEC UNIVERGE SV9100 Features And Specifications page 1097

Program
Program Name/Description
Number
Single Line Telephone Basic Data Setup –
15-03-08
Answer On-Hook when Holding (SLT)
Enable/Disable Answer ON-Hook when Holding
for SLT terminals.
Single Line Telephone Basic Data Setup –
15-03-09
Caller ID Function - For External Module
Enable/Disable the Caller ID FSK signal for an
external Caller ID module or a 3rd-Party vendor
telephone with Caller ID display.
Important:
If voice mail is used, this setting must be
disabled for the system integration codes to be
correct.
With a 2500 set (no Caller ID) installed, this
must be set to 0 for incoming callers to have a
talk path.
Single Line Telephone Basic Data Setup –
15-03-10
Caller ID Name
Determine if an extension user telephone
should display the Caller ID name.
Single Line Telephone Basic Data Setup –
15-03-14
Forwarded Caller ID Display Mode
Determine what the display shows when a
multiline terminal receives a forwarded outside
call.
20-03-01 System Options for Single Line Telephones
– SLT Call Waiting Answer Mode
For a busy single line (500/2500 type)
telephone, set the mode used to answer a
camped-on trunk call.
For ESL sets, enable this option (1) to allow the
user to dial Service Code for Voice Mail
Conversation Record.
20-03-02 System Options for Single Line Telephones
– Ignore Received DP Dial on DTMF SLT
Port
Define whether the system should receive dial
pulse and DTMF signals (0) or ignore dial pulse
and only accept DTMF signals (1).
20-03-03 System Options for Single Line Telephones
– SLT DTMF Dial to Trunk Lines
Set the SLT phones to (0). Collect all digits
before sending or (1), send out immediately
after receiving. When using a third-party
external paging device, set this option to 1. In
addition, set Program 20-03-04 to 1.
Input Data
0 = Disable (No)
1 = Enable (Yes)
0 = Disable
1 = Enable
0 = Disable
1 = Enable
0 = Calling Extension Number
(Calling)
1 = External Caller ID (Forward)
0 = Hookflash (Hooking)
1 = Hookflash + Service Code
794
Service Code 654 is for Live
Recording at SLT (Program
11-12-53).
0 = Do not ignore (No)
1 = Ignore (Yes)
0 = Receive all dialed data,
before sending (All)
1 = Direct through out (Direct)
1097
Default
1
0
1
0
0
0
0