D8129 Octo-Relay Module - Bosch B9512G-E Installation Manual

Control Panels
Wiring the terminal strip
Refer to the next section for information on how to wire the terminal strip.
11.2.2

D8129 Octo-relay Module

The D8129 Octo-relay Module is an eight relay output expansion device that connects to
control panel using the B600.
You can assign alarm output, auxiliary relay, sensor reset, arming status, point status, alarm
memory, or remote functions to the outputs individually. Refer to Output Parameters in RPS
Help, in the Installer Services Portal programming tool (available in Europe, Middle East,
Africa, and China) Help, or in the control panel Program Entry Guide for programming details.
D8129 Restricted for Fire Systems
D8129 relay outputs are not supervised and cannot be used in fire or combined fire and
burglary installations for primary indicating devices. For supervised relay outputs use a B308.
Address settings
Five switches on the module determine the eight relay output numbers. Set the address
before installing the module. For more information, refer to D8129 address settings, page 168.
Installation
For detailed instructions, refer to the corresponding document listed in Related
documentation, page 13.
Bosch Security Systems, Inc. Installation Manual
Off-board outputs | en 71
2018.07 | 10 | F.01U.303.996