B299 Popex Module; Sdi2 Address Settings; Supervision - Bosch B9512G-E Installation Manual

Control Panels
Dual EOL resistor circuit style
Notice!
EOL resistors
For the dual EOL resistor circuit style order ICP-1K22AWG-10, package of 10 1.0 kΩ EOL
resistors.
Point
COM
Callout - Description
1 - Point sensor loop terminals
2 - Normally closed device (contact)
3 - 1.0 kΩ resistor at device
4 - 1.0 kΩ resistor at EOL (end-of-line)
13.2

B299 POPEX Module

The B299 POPEX Module is an SDI2 compatible device. The module communicates to the
control panel over the SDI2 bus, and provides support for up to 100 POPIT (Point Of
Protection Input Transponder) devices. This occurs over a single expansion loop using two
pairs of terminals.
The control panels provide up to the following number of modules:
–
–
The module connects to the SDI2 bus on control panel using SDI2 terminals, or using the SDI2
interconnect wiring connector. You can connect more than one module to the control panel by
wiring them in series.
For detailed instructions, refer to the corresponding document listed in Related
documentation, page 13.
13.2.1

SDI2 address settings

Notice!
The module reads the address switch setting only during module power up. If you change the
setting after you apply power to the module, you must cycle the power to the module in order
for the new setting to take effect.
If multiple B299 modules reside on the same system, each B299 module must have a unique
address.
The number of points allowed by the control panel determines the valid addresses.
For valid point numbers, refer to B299 address settings, page 165.
13.2.2

Supervision

The control panel automatically supervises any B299 on the SDI2 bus when an associated
point has its source programmed for POPEX.
Bosch Security Systems, Inc.
2
1
NC
3
B9512G. 6
B8512G. 1
4
Installation Manual
Off-board points | en 79
2018.07 | 10 | F.01U.303.996