Rf Repeater Menu > [2] Replace Repeater; Rf Repeater Menu > [3] Remove Repeater; Rf Diagnostic Menu > [1] Rf Points - Bosch B9512G-E Installation Manual

154 en | Keypad Installer menu
6.
7.
20.2.5 [2] RF Repeater Menu > [2] Replace Repeater
In this menu, you can replace Repeater points.
Replace Repeater
1.
2.
3.
4.
5.
6.
20.2.6 [2] RF Repeater Menu > [3] Remove Repeater
In this menu, you can replace Repeater points.
Remove Repeater
1.
2.
3.
4.
5.
20.2.7 [3] RF Diagnostic Menu > [1] RF Points
You can obtain certain wireless point diagnostic information using a keypad and this menu.
Point State
1.
2.
3.
4.
5.
Point Signal
1.
2.
3.
2018.07 | 10 | F.01U.303.996
Initiate discovery on a RADION repeater by opening the cover, or press the RESET button
on an Inovonics repeater.
When the keypad indicates that the repeater was added, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [2] RF Repeater Menu > [2] Replace Repeater. The keypad lists any
existing repeaters.
Use /Previous or /Next to scroll through the list of repeaters, and go to the repeater
you want to replace, or simply enter the repeater number.
Press Enter to replace the device. The keypad instructs you to reset the new device.
Initiate discovery on a RADION device per the device instructions, or press the RESET
button on an Inovonics device.
When the keypad indicates that the repeater was replaced, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [2] RF Repeater Menu > [3] Remove Repeater. The keypad lists any
existing repeaters.
Use /Previous or /Next to scroll through the list of repeaters, and go to the repeater
you want to remove, or simply enter the repeater number.
Press Enter to remove the device. The keypad removes the device and shows Repeater
removed.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [3] RF Diagnostic Menu > [1] RF Point Diagnostic > [1] Point State.
Use /Previous or /Next to scroll through the list, and go to the point for which you
want to view diagnostic information, or enter the point number.
Press Enter to view the state. The menu scrolls through the following sub-categories,
with the results of the diagnostic check: State, Tamper, Low-Battery, Maintenance.
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [3] RF Diagnostic Menu > [1] RF Point Diagnostic > [2] Point
Signal.
Use /Previous or /Next to scroll through the list, and go to the point for which you
want to view diagnostic information, or enter the point number.
Installation Manual
Control Panels
Bosch Security Systems, Inc.