Bosch B9512G-E Installation Manual page 87

Control Panels
Caution!
Remove all power (AC and battery) before making any connections. Failure to do so might
!
result in personal injury and/or equipment damage.
Installing the module
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Refer to the EN4200 EchoStream Serial Receiver Installation Instructions for mounting and
Wiring to the control panel
Use the terminal strip labeled with PWR, A, B, and COM on the module to wire to the SDI2
terminals labeled on the control panel. Wire the module within the distances rated for the
module: 600 ft. (183 m) with 22 AWG (0.6 mm) wire or 1000 ft. (305 m) with 18 AWG (1.0
mm) wire.
Route the cabling through the control panel enclosure, and through the EN4200 housing.
olice olice
ting ting
ire ire
Callout ᅳ Description
1 ᅳ Control panel
2 ᅳ Module
3 ᅳ Terminal strip wiring
Bosch Security Systems, Inc.
Set the module address using the address switch before you install it in the EN4200
housing.
Use the address switch to set the module address.
Use a slotted screwdriver to press the housing release tabs and open the housing.
Remove the backing from one side of the supplied Velcro piece to show the Velcro
adhesive.
Put the adhesive side of the Velcro onto the back of the module.
Remove the other backing from the Velcro.
Insert the module into the housing.
Connect the serial ports on the B820 and EN4200.
Push gently on the B820 to make sure that the Velcro sticks.
wiring instructions for the receiver.
MOD-2
MODULE RELEASE
1
MOD-1
29 30
PWR+/R PWR+/R
28 29
A/Y A/Y
28 27
B/G B/G
27 26
COM/B COM/B
PWR+/R PWR+/R 26 26
R
A/Y A/Y 25 25
Y
B/G B/G 24 24 G
COM/B COM/B B
23 23
3
Installation Manual
Wireless modules | en
2
2018.07 | 10 | F.01U.303.996
87