120 en | Keypad Installer menu
3.
4.
5.
20.2.4
[2] RF Repeater Menu > [1] Add Repeater
In this menu, you can add Repeater points.
Add Repeater
1.
2.
3.
4.
5.
6.
20.2.5
[2] RF Repeater Menu > [2] Replace Repeater
In this menu, you can replace Repeater points.
Replace Repeater
1.
2.
3.
4.
5.
6.
20.2.6
[2] RF Repeater Menu > [3] Remove Repeater
In this menu, you can replace Repeater points.
Remove Repeater
1.
2.
3.
4.
5.
20.2.7
[3] RF Diagnostic Menu > [1] RF Points
You can obtain certain wireless point diagnostic information using a keypad and this menu.
Point State
2017.04 | 15 | F.01U.287.180
Use
/Previous or
/Next to scroll through the list of wireless points, and go to the
point for which you want to remove, or simply enter the point number.
Press Remove or Enter to remove the device. The keypad shows Point RFID removed.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [2] RF Repeater Menu > [1] Add Repeater. The keypad lists any
repeaters.
Use
/Previous or
/Next to scroll through the list, and go to the repeater number for
which you want to add a repeater, or simply enter the repeater number.
Press Enter to add the device. The keypad instructs you to reset the device.
Initiate discovery on a RADION device per the device instructions, or press the RESET
button on an Inovonics device.
When the keypad indicates that the repeater was added, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [2] RF Repeater Menu > [2] Replace Repeater. The keypad lists any
existing repeaters.
Use
/Previous or
/Next to scroll through the list of repeaters, and go to the repeater
you want to replace, or simply enter the repeater number.
Press Enter to replace the device. The keypad instructs you to reset the new device.
Initiate discovery on a RADION device per the device instructions, or press the RESET
button on an Inovonics device.
When the keypad indicates that the repeater was replaced, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [2] RF Repeater Menu > [3] Remove Repeater. The keypad lists any
existing repeaters.
Use
/Previous or
/Next to scroll through the list of repeaters, and go to the repeater
you want to remove, or simply enter the repeater number.
Press Enter to remove the device. The keypad removes the device and shows Repeater
removed.
Escape from the menu.
Installation Manual
Control Panels
Bosch Security Systems, Inc.