Genie GTH-2506 AU.3 Operator's Manual page 72

March 2018
Attachments
2 m Extension Jib
(part number AUS100020)
TECHNICAL DATA
Payload
Width
Length
Height
Weight
The 2 m extension jib has been designed to
support a load of 2000 kg. The max payload
corresponds to the nominal capacity rating
of the telehandler on which it is installed and
may be reduced as indicated on the load
charts supplied with the equipment.
70
Application
Quick-coupling fitted attachment for lifting loads
by means of slings.
Safety
Strictly obey the general safety precaution given
in "Safety" chapter.
Never lift incorrectly slung loads.
Avoid abrupt acceleration or deceleration.
Avoid load oscillations, and especially do not
move the load from the vertical pull line.
Do not pull crosswise and do not tow.
Operation
Couple the jib and hold it in position by means of
the locking cylinder. All loads must be lifted with
slings or chains in compliance with all relevant
regulations. To handle the load, raise and rotate
the telescopic boom of the telehandler.
Maintenance
Visually Check the jib for damage before using it.
Check the safety catch is in good working order.
• Capacity is in accordance with the load
2000 kg
chart supplied for this attachment
1000 mm
• Load must be kept low while travelling-
2225 mm
use short slings.
• Pick and carry position
675 mm
-max boom angle 35°
205 kg
-boom fully retracted
-maximum drive speed 0.4 m/s (walking
speed)
-maximum downhill slope 5°
-maximum sidewards slope 5°
For use of this attachment refer to "Suspended
Load Hazard" section.
GTH-2506 AU.3
Second Edition - Second Printing
Part No. 57.0009.0730