Genie GTH-2506 AU.3 Operator's Manual page 16

March 2018
Work Area Safety
Battery Safety
Burn Hazards
Batteries contain acid.
Always wear protective
clothing and eye wear when
working with batteries.
Avoid spilling or contacting
battery acid. Neutralize
battery acid spills with baking
soda and water.
Explosion Hazards
Keep sparks, flames and
lighted tobacco away from
batteries. Batteries emit
explosive gas.
14
Electrocution Hazard
Avoid contact with electrical terminal.
Using the Charger (if equipped), be sure the device
works at 12 Volt and doesn't exceed 15 Ampere.
During maintenance or repair works, and while
welding, disconnect the battery by turning the cut-out
switch (see Inspection for Decals section).
After turning off the cut-out switch, wait for 60 seconds
before starting the engine.
Employer's Responsibilities
Employers are responsible for providing a safe
work environment and for complying with local and
national governmental regulations.
Personal Safety
Be sure that everyone working on or near this machine
is familiar with the applicable safety precautions.
GTH-2506 AU.3
Second Edition - Second Printing
Part No. 57.0009.0730