Genie GTH-2506 AU.3 Operator's Manual page 33

Second Edition - Second Printing
Do Not Operate Unless:
 You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1. Avoid hazardous situations.
2. Always perform a pre-operation inspection.
3. Always perform function tests prior to use.
4. Inspect the workplace.
Know and understand the function tests
before going on to the next section.
5. Only use the machine as it was intended.
Workplace Inspection
Fundamentals
The workplace inspection helps the operator
determine if the workplace is suitable for safe machine
operation. It should be performed by the operator prior
to moving the machine to the workplace.
It is the operator's responsibility to read and remember
the workplace hazards, then watch for and avoid them
while moving, setting up and operating the machine.
Part No. 57.0009.0730
Workplace Inspection Checklist
Be aware of and avoid the following hazardous
situations:
 drop-offs or holes
 bumps, floor obstructions or debris
 sloped surfaces
 unstable or slippery surfaces
 overhead obstructions and high voltage
conductors
 hazardous locations
 inadequate surface support to withstand all load
forces imposed by the machine
 wind and weather conditions
 the presence of unauthorized personnel
 other possible unsafe conditions
GTH-2506 AU.3
March 2018
Inspections
31