Genie GTH-2506 AU.3 Operator's Manual page 28

March 2018
Inspections
Pre-operation Inspection
 Be sure that the operator's and safety manuals
are complete, legible and in the storage container
located in the cab.
 Be sure that all decals are legible and in place.
See Inspections section.
 Check for hydraulic oil leaks and proper oil level.
Add oil if needed. See Maintenance section.
 Check for battery fluid leaks and proper fluid level.
Add distilled water if needed. See Maintenance
section.
 Check for engine oil leaks and proper oil level.
Add oil if needed. See Maintenance section.
 Air-filled tires models: Check for proper tire
pressure. Add air if needed. See Maintenance
section.
Check the following components or areas for damage,
improperly installed or missing parts and unauthorized
modifications:
 Electrical components, wiring and electrical
cables
 Hydraulic hoses, fittings, cylinders and
manifolds
 Fuel and hydraulic tanks
 Drive motors and drive hubs
 Boom wear pads
 Tires and wheels
 Mirrors /Camera system
 Engine and related components
26
 Limit switches
 Lights, alarms and beacons
 Pins, nuts, bolts and other fasteners
 - LMS front and rear cameras (if fitted) and
their cables;
Check entire machine for:
 Cracks in welds or structural components
 Dents or damage to machine
 Excessive rust, corrosion or oxidation
 Be sure that all structural and other critical
components are present and all associated
fasteners and pins are in place and properly
tightened.
 Be sure the windshield and windows and camera
system are clean and free of obstructions that
might limit visibility.
 Be sure the LMS cameras lens protector is clean
(use tissue and water when required) and that
the cameras mount is not loose.
 After you complete your inspection, be sure that
all guards, screens and compartment covers are
in place and secured.
GTH-2506 AU.3
Second Edition - Second Printing
Part No. 57.0009.0730