Genie GTH-2506 AU.3 Operator's Manual page 49

Second Edition - Second Printing
depending on outrigger position. The chart's load
zones change colour from green to orange or red
when the actual load reaches 90% and 100% of
the rated capacity.
Load chart area zoom function. Turn the
encoder wheel (3) clockwise to zoom into the
load chart area, or counter clockwise to zoom out.
Alternatively, press the pre-set zooming buttons
on the right hand side of the screen (1).
Boom position indicator (9). Position of the load
reference point is dynamically shown on the load
chart by a cursor.
Load chart part number (10). Load chart number
and revision is shown at the top left hand corner
of the load chart area.
Select attachment (11). Short description of
selected attachment.
Outrigger position (12). Outrigger position
changes from 'ON outriggers' to 'OFF outriggers'
dependingon outrigger configuration.
Load percentage graph (13). Actual load as
displayed as gradient vertical bar graph. As
you approach orange and red colours you are
apporaching 90% and 100% rated capacity.
Load percentage value (14). Actual load as
a percentage of rated capacity displayes as
numerical value.
Alarm icon (15). This icon appears when an
alarm or warning is active. The icon will disappear
when the alarm condition has been cleared.
Overload icon (16). Overload icon appears when
actual load has exceeded rated capacity.
Override icon (17). The override icon appears
when LMS override function is in use.
Part No. 57.0009.0730
Operating Instructions
Time/date (18). Current time/date. This value
toggles between time and date every 10 seconds.
Machine status (19). This icon indicates the
position of job-site/road/platform selector switch.
Actual load (20). Numerical value of load being
lifted.
Rated capacity (21). Machine capacity based on
attachment selected, boom position and outrigger
configuration.
Audible alarm ON/OFF (22). Press button to the
right of the icon to mute the overload alarm. Press
again to unmute.
Front camera (if equipped) (23). Press button
next to the icon to switch to front camera view.
Radius (24). This value represents the horizontal
distance between the front vertical projection of
the front tyres/outriggers to the vertical projection
of the load reference point.
Rear camera (if equipped) (25). Press button
next to the icon to switch to rear camera view.
Height (26). This value represents the vertical
distance from the ground to the load reference
point.
Secondary home screen (27). Press button next
to the icon to switch to secondary home screen.
Secondary Home Screen
This information screen can only be accessed
from the primary home screen. It displays
machine geometrical information, user data, and
description of current alarms and warnings (figure
11).
GTH-2506 AU.3
March 2018
47