Genie GTH-2506 AU.3 Operator's Manual page 71

Second Edition - Second Printing
Fixed Hook
(part number AUS10011)
TECHNICAL DATA
Payload
Width
Length
Height
Weight
The fixed hook has been designed to support a
load of 4000 kg. The max payload corresponds
to the nominal capacity rating of the telehandler
on which it is installed and may be reduced as
indicated on the load charts supplied with the
equipment.
Part No. 57.0009.0730
Application
Quick-coupling fitted attachment for lifting loads by
means of special slings.
Safety
Strictly obey the general safety precautions given in
section "Safety".
Do not oscillate the load.
Do not drag hooked loads.
Lift the load before extending the boom.
Operation
Fork the hook and hold it in position by means of the
locking cylinder.
All loads must be bridled with special textile slings or
chains in compliance with all pertinent regulations.
To handle the load, raise and rotate the telescopic
boom of the handler.
Maintenance
Visually check the hook for damage before using
it. Check the safety catch is in good working order.
4000 kg
• Capacity is in accordance with the load chart
990 mm
supplied for this attachment
• Load must be kept low while travelling - use
615 mm
short slings
510 mm
• Pick and carry position
150 kg
-max boom angle 35°
-boom fully retracted
-maximum drive speed 0.4 m/s (walking speed)
-maximum downhill slope 5°
-maximum sidewards slope 5°
For use of this attachment, refer to "suspended
load Hazard" section
GTH-2506 AU.3
March 2018
Attachments
69