Mitsubishi Electric MELSEC L Series Manual page 84

4
ANALOG I/O MODULE REPLACEMENT
Item
Number of analog output points
Digital input
Voltage
Analog output
Current
I/O characteristics
Maximum resolution
Overall accuracy
(Accuracy for the maximum analog
output value)
Absolute maximum output
Conversion speed
Output short protection
Insulation method
Dielectric withstand voltage
Insulation resistance
Conversion speed during simple
loop control
Number of occupied I/O points
Connection terminal
Applicable wire size
Applicable solderless terminal
4
- 5
Digital input value
1/4000 1/8000
4000 8000
2000 4000
0 0
-2000 -4000
-4000 -8000
*1 The offset value is set to 0V and the gain value is set to 10V (factory default setting).
*2 The offset value is set to 4mA and the gain value is set to 20mA (factory default setting).
Between the input terminal and programmable controller power supply: Photocoupler
Between channels: Not insulated
Between the input terminal and programmable controller power supply: 500VACrms, for 1 minute
Between the input terminal and programmable controller power supply: 500VDC, 5M or higher
A1S63ADA
1 channels/module
1/4000 setting:
voltage: -4000 to 4000, current: 0 to 4000
1/8000 setting:
voltage: -8000 to 8000, current: 0 to 8000
1/12000 setting:
voltage: -12000 to 12000, current: 0 to 12000
-10 to 0 to 10VDC
(External load resistance value: 2K to 1M)
0 to 20mA
(External load resistance value: 0 to 600)
Voltage output value
1/12000
*1
12000 10V
6000 5V
0 0
-6000 -5V
-12000 -10V
1/4000 2.5mV (10V) 5µA (20mA)
1/8000 1.25mV (10V) 2.5µA (20mA)
1/12000 0.83mV (10V) 1.7µA (20mA)
±1%
(voltage: ±100mV, current: ±200µA)
Voltage: ±12V
Current: 28mA
1/4000 setting: 1ms/channel
1/8000 setting: 2ms/channel
1/12000 setting: 3ms/channel
Available
1/4000 setting: 4ms
1/8000 setting: 7ms
1/12000 setting: 9ms
32 points
(I/O assignment: special 32 points)
20-point terminal block
2
0.75 to 1.5mm
(Applicable tightening torque: 39 to 59N•cm)
1.25-3, 1.25-YS3A, 2-3.5, 2-YS3A,
V1.25-M3, V1.25-YS3A, V2-S3, V2-YS3A
Analog output
Current output value
*2
20mA
12mA
4mA
–