Mitsubishi Electric MELSEC L Series Manual page 213

7
POSITIONING MODULE REPLACEMENT
Changed function
The command in-position width is expanded.
Command in-position
• A1SD75P-S3: 1 to 32767000
function
• LD75P/D: 1 to 2147483647
Positioning start No. 7004 to 7010 (block start designation) and 8000 to 8049 (indirect designation) are deleted.
With the LD75P/D, the number of blocks has been changed to 5 (7000 to 7004).
block start data
(With the A1SD75P-S3, this data is called "Positioning start information".)
Start history The configuration of "start information" and "start No." is changed so that the start No. can be directly checked.
Basic parameter1
When the CPU module is powered on or reset, the valid value is only the first value after PLC READY (Y0)
turns off to on.
" Pulse output mode"
Pr.5
Detailed parameters
" Software stroke
Pr.15
limit valid/invalid setting"
0 Software stroke limit is disabled at
(Factory default setting) the manual operation.
Software stroke limit is enabled at
1
the manual operation.
Description
A1SD75P-S3
Software stroke limit is enabled at
the manual operation.
Software stroke limit is enabled at
the manual operation.
LD75P/D
7
- 9