Mitsubishi Electric MELSEC L Series Manual page 23

2
ANALOG INPUT MODULE REPLACEMENT
High speed: 20µs/channel (default)
Medium speed: 80µs/channel
Low speed: 1ms/channel
Between the I/O terminal and programmable controller power supply: Photocoupler
Between channels: Not insulated
Between the I/O terminal and programmable controller power supply: 500VACrms, for 1 minute
Between the I/O terminal and programmable controller power supply: 500VDC, 10M or higher
(I/O assignment: intelligent 16 points)
R1.25-3 (Solderless terminals with an insulation sleeve cannot be used.)
L60AD4
Voltage: ±15V
Current: ±30mA
4 channels/module
Up to 50000 times
16 points
18-point terminal block
2
0.3 to 0.75mm
0.52A
0.19kg
: Compatible, : Partial change required, ×: Incompatible
Compatibility Precautions for replacement
The conversion speed of L60AD4 is faster
than A1S64AD. Therefore, noise which were
not imported to A1S64AD can be imported
as analog signals. In this case, use the
averaging processing function to remove the
effect of noise.
The number of occupied I/O points is
changed to 16 points.
×
×
Wiring needs to be changed.
×
Recalculation of internal current
consumption (5VDC) is required.
2
- 5