Panasonic KT4R User Manual page 48

Characters,
Factory Default
[41] ARW
• Sets ARW (anti-reset windup).
• Setting range: 0 to 100%
Available only for PID control.
[42] Manual reset
• Sets the reset value manually.
• Setting range:
If a value larger than 100.0% is set in [OUT1 proportional band], the setting range
will be
Available for P control and PD control.
[43] OUT1 proportional cycle
• Sets proportional cycle for OUT1.
For relay contact output, if the proportional cycle time is decreased, the frequency
Factory default:
of the relay action increases, and the life of the relay contact is shortened.
• Relay contact
• Setting range: 0.5, or 1 to 120 seconds
output: 30 sec.
Not available for Direct current output type, or if OUT1 is in ON/OFF control.
• Non-contact
voltage output:
3 sec.
[44] OUT1 ON/OFF hysteresis
• Sets ON/OFF hysteresis for OUT1.
• Setting range: 0.1 to 1000.0
DC voltage, current inputs: 1 to 10000
Available only when OUT1 is in ON/OFF control.
[45] OUT1 high limit
• Sets OUT1 high limit value.
• Setting range: OUT1 low limit value to 100%
(Direct current output type: OUT1 low limit value to 105%)
Not available if OUT1 is in ON/OFF control.
[46] OUT1 low limit
• Sets OUT1 low limit value.
• Setting range: 0% to OUT1 high limit value
(Direct current output type: -5% to OUT1 high limit value)
Not available if OUT1 is in ON/OFF control.
[47] OUT1 rate-of-change
• Sets changing value of OUT1 MV for 1 second.
See 'OUT1 rate-of-change' on p. 52.
• Setting range: 0 to 100%/second
Setting the value to 0 disables this function.
Not available if OUT1 is in ON/OFF control.
(*1) The placement of the decimal point follows the selection.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Setting Item, Function, Setting Range
Proportional band value
100.0.
( ),
(*1)