Compaq ProLiant DL580 Setup And Installation Manual page 86

4-16 Compaq ProLiant DL580 Server Setup and Installation Guide
Figure 4-6. Bracket rail with inner slide
5. Identify the front of the rack mounting bracket and the bracket rail: the
front of the rack mounting bracket has alignment tabs on its flange and
the front of the bracket rail allows the inner slide to move forward on
ball bearings.
6. Lay the bracket rail inside of the rack mounting bracket, with the front
of both pieces oriented in the same direction. Align the front screw hole
in the rack mounting bracket and the bracket rail.
7. Extend the inner slide from the front of the bracket rail. With this piece
extended, you will see three screw holes aligned in the rack mounting
bracket and the bracket rail
near the back end of the bracket rail and the front screw hole that is
accessible through a slot in the inner slide.
8. Fasten the bracket rail to the rack mounting bracket with three 8-32 x
1/4-inch slotted screws. (Do not use nuts or washers with the screws.)
See step of the Figure 4-7.


9. Adjust the inner slide to access two additional screw holes (one at a
time) through the slotted opening in the inner slide. Use two more 8-32
x 1/4-inch slotted screws to fasten the bracket rail to the rack mounting
bracket. See steps
. These are the two exposed screw holes


and of the following figure.