Compaq ProLiant DL580 Setup And Installation Manual page 121

6-12 Compaq ProLiant DL580 Server Setup and Installation Guide
3. Once the new adapter is detected, NCMCON automatically asks if you
want to configure and apply power to the slot. If you answer yes, power
is applied to the slot, the green LED is lit, and the status of the slot on
the console changes to Ready. If you answer no, the console status does
not change.
4. Press Enter to go to the Slot Options menu.
5. Use the arrow keys to highlight Replace Adapter and press Enter.
NCMCON processes the replace request.
Novell intraNetWare Operating System
Messages
Adapter Not Same – Adapter is not the same as the adapter being replaced.
PCI Hot Plug replacement cannot continue.
Card Functioning – Adapter in slot is currently functioning. Add/Replace is
ignored.
Driver in Use – Adapter is currently in use. Do you wish to force removal?
Driver Loaded – Driver for adapter is currently loaded. Unload driver and
select again.
General Failure – Could not perform action because of system failure.
No Hot-Plug Driver – PCI Hot Plug driver is not responding. Check to make
sure that the appropriate hot-plug driver is loaded.
Remove Not Supt – Remove action is not supported for the adapter/slot.
Switch Open – Slot cannot be initialized because the switch is open. Close the
switch and try Add/Replace again.
Unknown Slot – Add/Remove performed on an unknown slot. Try the
command again.
Replace Load Driver – Adapter successfully replaced. Please load driver at this
time.
Refer to the online PCI Hot Plug Administration Guide for more information
on troubleshooting and error messages.