Compaq ProLiant DL580 Setup And Installation Manual page 140

Setup could not determine the type of computer you have, or you have chosen to
manually specify the computer type.
Select the computer from the following list, or select "Other" if you have a device
support disk provided by your computer manufacturer.
NOTE: If you do not get this screen, but are prompted for Windows NT Setup disk 2,
press F3 twice to exit and try again.
d. Select Other.
e. When prompted for a manufacturer-supplied hardware support disk,
insert the Compaq Server Support for Microsoft Windows NT 4.0
and press Enter.
f. Select the appropriate Compaq HAL for your server (SystemPro
Multiprocessor, MPS Multiprocessor, or Uniprocessor).
g. Insert the Compaq Server Support for Microsoft Windows NT 4.0,
Disk 2 into the diskette drive and press Enter. You have now
completed the installation of the Compaq HAL.
h. When prompted, insert the Windows NT Server Setup, Disk 2.
i. Select Express Setup as the installation method.
j. When prompted, insert the Windows NT Server Setup, Disk 3.
k. When Setup prompts that the CD-ROM drive has been found, press
S to specify additional devices.
l. Select Other.
m. When prompted, insert a disk provided by the hardware
manufacturer and press Enter.
n. Insert the Compaq Server Support for Microsoft Windows NT 4.0
into the diskette drive and press Enter.
o. Select Compaq 32-bit SCSI-2 Controllers for Windows NT 4.0 and
press Enter. The screen that lists recognized mass storage devices is
displayed.
p. Press Enter to continue, or press S to specify additional storage
devices, such as Compaq Drive Array.
q. Follow the remaining Windows NT Server Setup instruction screens
to complete your installation of Windows NT Server.
Installing the Microsoft Windows NT 4.0
Operating System
1. Start the server from the created start diskette labeled
Windows NT 4.0—Disk 1.
Server Configuration and Utilities 7-17