Compaq ProLiant DL580 Setup And Installation Manual page 46

5. Locate an available processor slot on the system board. The following
illustration shows a detailed view of the server with four processors
installed on the system board.
NOTE: Processor slots are numbered 1 through 4 on the install labels and on the
illustrated parts map. By default, Compaq ProLiant DL580 servers are shipped with at
least one processor installed in slot 1. Remaining slots may be populated in any order.
Figure 2-4. Processor slot locations
Processor Slot Locations
Item





CAUTION: It is necessary to fully loosen the blanking panel retention screw
before removing the processor module to avoid possible damage to the
processor.
6. Prepare to remove the blanking panel from the selected slot by fully
loosening the blanking panel retention screw
levers .

Table 2-2
Component
Slot 1
Slot 2
Slot 3
Slot 4


Installing Hardware Options 2-9
4
3
2
1
and opening the ejector