Compaq ProLiant DL580 Setup And Installation Manual page 51

2-14 Compaq ProLiant DL580 Server Setup and Installation Guide
2. On the memory board, squeeze in on the spring-loaded release latches
and flip up the retaining flaps
1
2
Figure 2-8. Removing the standard 16-DIMM memory board
3. Lift the board out of the server
Installing Additional DIMM Modules
Before installing additional memory, back up all server data and power down
the server as described in the section on "Installing Non-Hot-Plug Options."
1. Remove the memory board from the system as described in the previous
section, "Removing the Memory Board."
CAUTION: Always support the memory expansion board or apply counter
pressure while inserting a module.
2. Support the memory board and align the key slots on the bottom edge of
each DIMM module with the tabs in the memory slot.
3. Insert each module directly into the slot by pressing the memory module
in toward the board with equal pressure on both outer corners
the module is properly seated
the latches snap into place and lock the module into place.
.

1
2
3
.

. When the module is seated properly,




until