Compaq ProLiant DL580 Setup And Installation Manual page 65

2-28 Compaq ProLiant DL580 Server Setup and Installation Guide
1. Locate and remove the blanking panel bay by squeezing the right
retaining clip and pulling the blank out of the drive bay


Figure 2-17. Removing a blanking panel
2. Insert the hot-plug SCSI hard drive into the empty drive bay and push
until seated .


3. Push the drive lever in to lock the drive in place
Figure 2-18. Installing a hot-plug SCSI hard drive
4. Place the hot-plug SCSI hard drive online as directed by your operating
system instructions. If the drive was replaced, the array controller does
an auto-spin up and starts rebuilding the drive.
2
1

1
2
.

.