2-10 Compaq ProLiant DL580 Server Setup and Installation Guide
7. Pull the blank out of its slot
Figure 2-5. Removing the blanking panel from the processor slot
8. Align the new processor module with the processor slot and push the
module into the slot
9. Press the ejector paddles
simultaneously seats the board into the slot and locks the processor into
place.
10. When ejectors are seated, complete the installation by pressing the
spring-mounted retention screw until it stays down. Continue rotating
the retention screw
2
Figure 2-6. Inserting the processor into the processor slot
and retain it for future use.
2
2
1
3
.
down at the same time. This motion
until it is finger-tight.
3
1
2