Compaq ProLiant DL580 Setup And Installation Manual page 45

2-8 Compaq ProLiant DL580 Server Setup and Installation Guide
NOTE: In Compaq ProLiant DL580 servers, each Pentium III Xeon processor is keyed to fit
into each processor slot one way only.
Installing a Processor
To install a processor, use the following procedure:
1. Ensure that your server has the latest system BIOS appropriate to the
processor that you are installing. To download the latest system
ROMPaq ä firmware, follow the installation instructions on the Compaq
website:
www.compaq.com/support/servers
2. Follow the instructions for "Preparing to Install Non-Hot-Plug Options."
3. Loosen the thumbscrews and center screw on the server front panel
NOTE: Use the Torx T-15 screwdriver provided with your server to loosen the center
screw.
4. Slide the top access panel toward the rear of the unit about an inch
and then lift the top access panel off the unit
NOTE: Core frequency switch settings are located on the label attached to the underside
of the top access panel. Refer to this information for switch settings associated with
different processor speeds.
1
1
Figure 2-3. Removing the top access panel
2
1
.

.