Section 4 • Repair Procedures
7-1
Turntable Rotation Motor
How to Remove the Turntable
Rotation Motor
Note: When removing a hose assembly or fi tting,
the O-ring on the fi tting and/or hose end must be
replaced and then torqued to specifi cation during
installation. Refer to Section 2, Hydraulic Hose and
Fitting Torque Specifi cations.
1 Secure the primary boom to the turntable with
the hold-down latch.
Note: The hold-down latch is located at the
platform end of the primary boom.
2 Remove the cover support (if equipped).
3 Tag, disconnect and plug the hydraulic hoses.
Cap the fi ttings on the turntable rotation motor.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
4 Remove the turntable rotation motor mounting
fasteners and remove the turntable rotation
motor from the machine.
4 - 34
Turntable Rotation Components
Genie TZ-34/20
January 2016
Part No. 825934