Per Output For Function Block - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
3.3.5 Per output for function
Block
© 2008 ABB STOTZ-KONTAKT GmbH
Commissioning
No. Function
23, 48,
Block
1)
73, 98
This object is enabled if in parameter window
The object is used for blocking an output to prevent unwanted operation. Further incoming
telegrams are ignored and not evaluated in the background. The incoming telegrams will
only be evaluated after a renewed release of the output. The lighting remains unchanged
when a block is removed.
A block during the staircase lighting or control function on the other hand leads to an
immediate blocking of the output and freezing of the brightness value. After unblocking,
the staircase lighting function continues with dimming (prewarning). If lighting control or
slave operation were active before the block they will be re-established.
The Block function has a lower priority than forced operation, refer to the
After bus voltage recovery or download the blocking is removed and the must be reset if
required.
Telegram value: 0 = remove block
1 = block active
1)
The numbers of the objects apply for outputs A to D.
Object name Data type
1 bit (EIS1)
Output X
DPT 1.003
the function Block is enabled.
X: Function
function
Flags
C, W
chart.
91